Influence of Technological Parameters on Surface Quality of Injection-Molded Parts

E-ISSN： 1662-9795|2016|686|131-136

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.686, 2016-03, pp. : 131-136

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Warpage of injection-molded thermoplastics parts: Numerical simulation and experimental validation

By Guo Zhiying Ruan Xueyu Peng Yinghong Li Dequn

Journal of Materials Engineering and Performance, Vol. 11, Iss. 2, 2002-04 ,pp. : 138-144

Springer Publishing Company

Access to resources Recommend Favorite

Researches Regarding the Influence of Technological Parameters on the Alloying Efficiency in Powder Injection Process

Key Engineering Materials, Vol. 2015, Iss. 660, 2015-09 ,pp. : 113-119

Trans Tech Publications

Access to resources Recommend Favorite

Length Change and Deformation of Powder Injection–Molded Compacts during Solvent Debinding

By Hu S.C. Hwang K.S.

Metallurgical and Materials Transactions A, Vol. 31, Iss. 5, 2000-05 ,pp. : 1473-1478

Springer Publishing Company

Access to resources Recommend Favorite

Evaluation of Mechanical Properties of Surface Layer Injection Molded Polypropylene by Nanoindentation Test

Key Engineering Materials, Vol. 2016, Iss. 699, 2016-08 ,pp. : 86-90

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Process Parameters on Precision of PM Parts

By Bocchini G. F.

Powder Metallurgy, Vol. 28, Iss. 3, 1985-01 ,pp. : 155-165

Maney Publishing

Access to resources Recommend Favorite