Influence of Molybdenum and Boron Addition on Fracture of P/M Parts

E-ISSN： 1662-9795|2016|682|265-269

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.682, 2016-03, pp. : 265-269

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Process Parameters on Precision of PM Parts

By Bocchini G. F.

Powder Metallurgy, Vol. 28, Iss. 3, 1985-01 ,pp. : 155-165

Maney Publishing

Access to resources Recommend Favorite

The Diffusion Treatment of PM Parts with Boron, Silicon, Chromium, and Carbon

By Chatterjee-Fischer R.

Powder Metallurgy, Vol. 20, Iss. 2, 1977-01 ,pp. : 96-99

Maney Publishing

Access to resources Recommend Favorite

Sintering Procedures for Aluminium P/M Parts and Metallographic Examination During the Process

By Amato I. Corso S. Sgambetterra E.

Powder Metallurgy, Vol. 19, Iss. 3, 1976-01 ,pp. : 171-175

Maney Publishing

Access to resources Recommend Favorite

Effects of lubricants and compacting pressure on the processability and properties of aluminum P/M parts

By Lefebvre L.-P. Thomas Y. White B.

Journal of Light Metals, Vol. 2, Iss. 4, 2002-11 ,pp. : 239-246

Elsevier

Access to resources Recommend Favorite

The Influence of Microstructure on the Fracture Development in Engineering Parts

Solid State Phenomena, Vol. 2017, Iss. 270, 2017-12 ,pp. : 74-79

Trans Tech Publications

Access to resources Recommend Favorite