Study on the Cutting Force and Machined Surface Quality of Milling AFRP

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|836|155-160

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.836, 2016-02, pp. : 155-160

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Spectral Properties of Milling and Machined Surface

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 570-577

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Machining Error Caused by Deflection of Tool Using Cutting Force in Ball End Milling of Inclined Surface

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 525-530

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Cutting Force and Cutting Power in High Feed Milling of Ti5Al5Mo5VCrFe

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 88-93

Trans Tech Publications

Access to resources Recommend Favorite

Machined surface plastic strain in orthogonal cutting by subsequent recrystallizations technique

By Iino Y.   Kim T.Y.   Mun S.D.  

Wear, Vol. 199, Iss. 2, 1996-11 ,pp. : 211-216

Elsevier

Access to resources Recommend Favorite

The Study of Coated Carbide Ball End Milling Tools on Inconel 718 Using Numerical Simulation Analysis to Attain Cutting Force and Temperature Predictive Models at the Cutting Zone

By  

Materials Science Forum, Vol. 2017, Iss. 882, 2017-02 ,pp. : 28-35

Trans Tech Publications

Access to resources Recommend Favorite