The Study of Coated Carbide Ball End Milling Tools on Inconel 718 Using Numerical Simulation Analysis to Attain Cutting Force and Temperature Predictive Models at the Cutting Zone

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2017|882|28-35

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.882, 2017-02, pp. : 28-35

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Simulation of cutting forces in ball-end milling

By Milfelner M.   Cus F.  

Robotics and Computer-Integrated Manufacturing, Vol. 19, Iss. 1, 2003-02 ,pp. : 99-106

Elsevier

Access to resources Recommend Favorite

Wear Behavior of Multilayer Nanocomposite TiAlSiN/TiSiN/TiAlN Coated Carbide Cutting Tool during Face Milling of Inconel 718 Superalloy

By  

Journal of Nano Research, Vol. 2017, Iss. 47, 2017-06 ,pp. : 11-16

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Machining Error Caused by Deflection of Tool Using Cutting Force in Ball End Milling of Inclined Surface

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 525-530

Trans Tech Publications

Access to resources Recommend Favorite

Temperature and wear of cutting tools in high-speed machining of Inconel 718 and Ti-6Al-6V-2Sn

By Maekawa K.   Kitagawa T.   Kubo A.  

Wear, Vol. 202, Iss. 2, 1997-01 ,pp. : 142-148

Elsevier

Access to resources Recommend Favorite

Cutting Parameters Optimization Based on Cutting Force Spectrum when Ball Milling A880 Gas Turbine Blade Profiles

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 578-583

Trans Tech Publications

Access to resources Recommend Favorite