Unbalance Response of HSK Hydraulic Chuck Tooling System for High-Speed Machining

E-ISSN： 1662-9752|2016|836|387-393

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.836, 2016-02, pp. : 387-393

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Frequency response measurement of high-speed photodetectors using the spectrum power method in a delay self-heterodyne system

By San Haisheng Li Lin Li Gang Chen Xuyuan Feng Boxue

Applied Physics B, Vol. 88, Iss. 3, 2007-08 ,pp. : 411-415

Springer Publishing Company

Access to resources Recommend Favorite

High Speed Machining of Hardened AISI 1045 Steel

Materials Science Forum, Vol. 2016, Iss. 861, 2016-08 ,pp. : 63-68

Trans Tech Publications

Access to resources Recommend Favorite

High‐Speed Performance Evaluation of a Large‐Scale Shared‐Bus Digital System

ELECTRONICS & COMMUNICATIONS IN JAPAN, Vol. 98, Iss. 10, 2015-10 ,pp. : 57-66

John Wiley & Sons Inc

Access to resources Recommend Favorite

Temperature and wear of cutting tools in high-speed machining of Inconel 718 and Ti-6Al-6V-2Sn

By Maekawa K. Kitagawa T. Kubo A.

Wear, Vol. 202, Iss. 2, 1997-01 ,pp. : 142-148

Elsevier

Access to resources Recommend Favorite

Performance evaluation of a permanent magnet brushless DC linear drive for high-speed machining using finite element analysis

By Abdou G. Tereshkovich W.

Finite Elements in Analysis and Design, Vol. 35, Iss. 2, 2000-05 ,pp. : 169-188

Elsevier

Access to resources Recommend Favorite