Influence of Tool Rotational Speed on the Mechanical Properties of Friction Stir Welded Al-Cu-Li Alloy

E-ISSN： 1662-9752|2016|857|228-231

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.857, 2016-06, pp. : 228-231

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Studies on Friction Stir Welding of Al-Cu-Li (AA2195) Alloy

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 274-277

Trans Tech Publications

Access to resources Recommend Favorite

Influences of Friction Stir Welding and Post‐Weld Heat Treatment on Al–Cu–Li Alloy

ADVANCED ENGINEERING MATERIALS (ELECTRONIC), Vol. 20, Iss. 2, 2018-02 ,pp. : n/a-n/a

John Wiley & Sons Inc

Access to resources Recommend Favorite

Impact of Tool Pin Geometry and Optimized Process Parameters on Mechanical Properties of Friction Stir Welded AZ80A Mg Alloy

Materials Science Forum, Vol. 2016, Iss. 866, 2016-09 ,pp. : 151-155

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Welding Parameters on Defects and Fracture Behavior of Friction Stir Welded 2195-T8 Al-Li Alloy Joints

Materials Science Forum, Vol. 2018, Iss. 913, 2018-03 ,pp. : 182-189

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure mapping of a friction stir welded AA2050 Al–Li–Cu in the T8 state

By De Geuser F. Malard B. Deschamps A.

Philosophical Magazine, Vol. 94, Iss. 13, 2014-05 ,pp. : 1451-1462

Taylor & Francis Ltd

Access to resources Recommend Favorite