Wetting measurements as a tool to predict the thermoplastic/thermoset rubber compatibility in two‐component injection molding

Publisher： John Wiley & Sons Inc

E-ISSN： 1097-4628|135|13|app.46046-app.46046

ISSN： 0021-8995

Source： JOURNAL OF APPLIED POLYMER SCIENCE, Vol.135, Iss.13, 2018-04, pp. : n/a-n/a

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Fabrication of highly expanded thermoplastic polyurethane foams using microcellular injection molding and gas‐laden pellets

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. : 2643-2652

John Wiley & Sons Inc

Access to resources Recommend Favorite

Fabrication of highly expanded thermoplastic polyurethane foams using microcellular injection molding and gas‐laden pellets

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 11, 2015-11 ,pp. : 2643-2652

John Wiley & Sons Inc

Access to resources Recommend Favorite

Approach to Fabricating Thermoplastic Polyurethane Blends and Foams with Tunable Properties by Twin‐Screw Extrusion and Microcellular Injection Molding

By  

ADVANCES IN POLYMER TECHNOLOGY, Vol. 33, Iss. 1, 2014-03 ,pp. : n/a-n/a

John Wiley & Sons Inc

Access to resources Recommend Favorite

A comparative study of the wear resistance of thermoplastic and thermoset coatings

By Xu Y.M.   Mellor B.G.  

Wear, Vol. 255, Iss. 1, 2003-08 ,pp. : 722-733

Elsevier

Access to resources Recommend Favorite

Assembly Injection Molding of a Hard Component with Integrated Rubberlike Shaft Seal and Investigation of its Quality

By  

Materials Science Forum, Vol. 2015, Iss. 825, 2015-08 ,pp. : 860-867

Trans Tech Publications

Access to resources Recommend Favorite