Wear of aluminium-base materials processed by mechanical milling in air or ammonia

Author： Iglesias P.   Bermudez M.-D.   Carrion F.J.   Martinez-Nicolas G.   Herrera E.J.   Rodriguez J.A.   Naranjo M.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.255, Iss.1, 2003-08, pp. : 569-572

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

SPD Processed Materials Mechanical Properties Determination with the Use of Miniature Specimens

By  

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 471-476

Trans Tech Publications

Access to resources Recommend Favorite

An Investigation of Forces and Tool Wear in Milling of Ni3Al-Base Superalloy

By  

Materials Science Forum, Vol. 2016, Iss. 861, 2016-08 ,pp. : 32-37

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Mechanical Properties of 6013 Aluminium Alloy Processed by a Combination of ECAP and Preaging Treatment

By  

Materials Science Forum, Vol. 2016, Iss. 877, 2017-01 ,pp. : 437-443

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Brazing and Heat Treatment Cycle on the Mechanical Properties of Base Materials

By  

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 310-313

Trans Tech Publications

Access to resources Recommend Favorite

Influence of ageing treatment on microstructure, mechanical properties and adhesive wear behaviour of 6063 aluminium alloy

By Büyükdogan Serkan   Gündüz Süleyman   Türkmen Mustafa  

Industrial Lubrication and Tribology, Vol. 66, Iss. 4, 2014-06 ,pp. : 520-524

Emerald Group Publishing Ltd

Access to resources Recommend Favorite