Machining stability in turning operation when cutting with a progressively worn tool insert

Author： Fofana M.S.   Ee K.C.   Jawahir I.S.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.255, Iss.7, 2003-08, pp. : 1395-1403

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

The Effect of Cutting Speed and Feed Rate on Surface Roughness and Tool Wear when Machining Machining D2 Steel

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite

Investigation into the relationship between tool-wear and cutting environments when turning EN32 steel

By Stanford M   Lister P.M.  

Industrial Lubrication and Tribology, Vol. 56, Iss. 2, 2004-03 ,pp. : 114-121

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Tool Life Analysis when Turning Ti-6Al-4V Using Vegetable Oil-Based Cutting Fluid

By  

Materials Science Forum, Vol. 2017, Iss. 882, 2017-02 ,pp. : 36-40

Trans Tech Publications

Access to resources Recommend Favorite

Cutting Temperature Experiment and Simulation Analysis of the Complex Groove Turning Insert

By  

Materials Science Forum, Vol. 2016, Iss. 861, 2016-08 ,pp. : 44-49

Trans Tech Publications

Access to resources Recommend Favorite

The performance of cutting fluids when machining aluminium alloys

By Mendes O.C.   â”´vila R.F.   AbrÃ’o A.M.   Reis Pedro   Davim J. Paulo  

Industrial Lubrication and Tribology, Vol. 58, Iss. 5, 2006-09 ,pp. : 260-268

Emerald Group Publishing Ltd

Access to resources Recommend Favorite