Fast patterning microstructures using inkjet printing conformal masks

ISSN： 0946-7076

Source： Microsystem Technologies, Vol.14, Iss.9-11, 2008-10, pp. : 1263-1267

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The presented paper describes a novel process using inkjet printing to pattern a conformal (built-on) mask onto photoresist for further microstructure formation. The advantages of using the inkjet printing conformal mask include no Cr photomask required, suitable for non-planar substrate, scalable for large area, and extreme low cost. The ink is ejected from the inkjet print-head controlled by the inkjet system. A CAD pattern from the designer can use this process to place the pattern ink onto the photoresist substrate. A conformal mask (made of ink) was directly built-on the photoresist substrate. The dried ink thickness has to be more than 1.8 μm thick as UV absorber. Following UV exposure, development, and ink removal, the designed microstructure patterns can be realized in photoresist such as microchannels and micro-columns.