Porosity Quatification of Cast Aluminium Alloys on Machined Surfaces Using Metallography and Eddy-Currents

By  

Key Engineering Materials, Vol. 2015, Iss. 647, 2015-06 ,pp. : 188-194

Trans Tech Publications

Access to resources Recommend Favorite

The influence of strontium on porosity formation in Al-Si alloys

By Dinnis C.   Dahle A.   Taylor J.   Otte M.  

Metallurgical and Materials Transactions A, Vol. 35, Iss. 11, 2004-11 ,pp. : 3531-3541

Springer Publishing Company

Access to resources Recommend Favorite

Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

By Shah Aqueel   Mufti Nadeem   Rakwal Dinesh   Bamberg Eberhard  

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 71-76

Springer Publishing Company

Access to resources Recommend Favorite

Machining Performance and Surface Integrity of AISI D2 Die Steel Machined Using Electrical Discharge Surface Grinding Process

By Choudhary Rajesh   Kumar Harmesh   Singh Shankar  

Journal of Materials Engineering and Performance, Vol. 22, Iss. 12, 2013-12 ,pp. : 3665-3673

Springer Publishing Company

Access to resources Recommend Favorite

Metallurgical Analysis of Crack Initiation of Wire-Cut Electrical Discharge-Machined Spline Actuators Made of 17-4 PH Stainless Steel

By Etemadi Ahmad-Reza  

Journal of Failure Analysis & Prevention, Vol. 11, Iss. 5, 2011-10 ,pp. : 493-496

Springer Publishing Company

Access to resources Recommend Favorite