Effect of working gap and circumferential speed on the performance of magnetic abrasive finishing process

Author： Jain V.K.   Kumar P.   Behera P.K.   Jayswal S.C.  

Publisher： Elsevier

ISSN： 0043-1648

Source： Wear, Vol.250, Iss.1, 2001-10, pp. : 384-390

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study of the surface modification resulting from an internal magnetic abrasive finishing process

By Yamaguchi H.   Shinmura T.  

Wear, Vol. 225, Iss. 1, 1999-04 ,pp. : 246-255

Elsevier

Access to resources Recommend Favorite

On the Effect of the Cutting Speed of a Water Jet Abrasive Cutting Process on the Surface Morphology of the Low Carbon Steel S235

By  

Materials Science Forum, Vol. 2018, Iss. 919, 2018-05 ,pp. : 92-100

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Media Degradation on Finishing Characteristics in Abrasive Flow Machining

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 127-132

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Unsteady and Steady Polishing Force in Magnetic Abrasive Finishing Using a Permanent Magnet End-Mill Tool

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 178-183

Trans Tech Publications

Access to resources Recommend Favorite

Simulation of an internal finishing process of rectangular tube using a magnetic field

By Kim J.-D.   Choi M.  

Wear, Vol. 184, Iss. 1, 1995-04 ,pp. : 67-71

Elsevier

Access to resources Recommend Favorite