The effect of machining parameters on surface roughness and material removal rate with cryogenic treated wire in WEDM

Author： Kapoor Jatinder Khamba Jaimal Singh Singh Sehijpal

ISSN： 1748-5711

Source： International Journal of Machining and Machinability of Materials, Vol.12, Iss.1-2, 2012-08, pp. : 126-141

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of wire electrical discharge machining parameters on surface roughness and volumetric material removal rate of tool steels

By Ramazi H. Nehzat N.

Ironmaking & Steelmaking, Vol. 36, Iss. 6, 2009-08 ,pp. : 451-455

Maney Publishing

Access to resources Recommend Favorite

Effects of Process Parameters on Material Removal Rate and Surface Roughness in Wedm of H-13 Die Tool Steel

Advanced Engineering Forum, Vol. 2018, Iss. 28, 2018-08 ,pp. : 55-66

Trans Tech Publications

Access to resources Recommend Favorite

Influence of machining parameters on surface roughness in finish cut of WEDM

By Han Fuzhu Jiang Jun Yu Dingwen

The International Journal of Advanced Manufacturing Technology, Vol. 34, Iss. 5-6, 2007-09 ,pp. : 538-546

Springer Publishing Company

Access to resources Recommend Favorite

Effect of process parameters on material removal rate and surface roughness in electric discharge drilling of Inconel 718 using graphite electrode

By Kuppan P.

International Journal of Manufacturing Technology and Management, Vol. 23, Iss. 3-4, 2011-02 ,pp. : 214-233

Inderscience Publishers

Access to resources Recommend Favorite

Effect of shallow cryogenic treated brass wire electrode on workpiece surface roughness in wire-EDM

By Kapoor Jatinder

International Journal of Materials Engineering Innovation, Vol. 3, Iss. 3-4, 2012-09 ,pp. : 190-203

Inderscience Publishers

Access to resources Recommend Favorite