Measurements of residual strains and stresses in laser formed plates of Ti-6Al-4V using synchrotron X-ray diffraction

ISSN： 1743-2847

Source： Materials Science and Technology, Vol.20, Iss.4, 2004-04, pp. : 465-472

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Comparison of residual stresses in Ti–6Al–4V and Ti–6Al–2Sn–4Zr–2Mo linear friction welds

By Frankel P. Preuss M. Steuwer A. Withers P. J. Bray S.

Materials Science and Technology, Vol. 25, Iss. 5, 2009-05 ,pp. : 640-650

Maney Publishing

Access to resources Recommend Favorite

Laser gas assisted nitriding of Ti–6Al–4V alloy and residual stress analysis

By Yilbas B. S. Arif A. F. M. Karatas C.

Surface Engineering, Vol. 25, Iss. 3, 2009-04 ,pp. : 228-234

Maney Publishing

Access to resources Recommend Favorite

Use of high temperature X-ray diffractometry to study phase transitions and thermal expansion properties in Ti-6Al-4V

By Pederson R. Babushkin O. Skystedt F. Warren R.

Materials Science and Technology, Vol. 19, Iss. 11, 2003-11 ,pp. : 1533-1538

Maney Publishing

Access to resources Recommend Favorite

Composite layer formation on Ti–6Al–4V surfaces by laser treatment using prepiaced SiC powder

By Mridha S. Baker T. N.

Surface Engineering, Vol. 13, Iss. 3, 1997-01 ,pp. : 233-237

Maney Publishing

Access to resources Recommend Favorite

Surface engineering of Ti–6Al–4V by nitriding and powder alloying using CW CO₂ laser

By Baker T. N. Selamat M. S.

Materials Science and Technology, Vol. 24, Iss. 2, 2008-02 ,pp. : 189-200

Maney Publishing

Access to resources Recommend Favorite