Layer manufactured production tooling incorporating conformal heating channels for transfer moulding of elastomer compounds

Author： Dalgarno K.W.   Stewart T.D.   Allport J.M.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.30, Iss.8, 2001-08, pp. : 384-388

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Numerical modelling for rotational moulding with non-isothermal heating

By Lim K.K.   Ianakiev A.   Hull J.B.  

Plastics, Rubber and Composites, Vol. 32, Iss. 10, 2003-12 ,pp. : 421-430

Maney Publishing

Access to resources Recommend Favorite

Characteristic of rapid heating cycle moulding and warpage analysis of products

By Li X-P   Zhao G-Q   Guan Y-J  

Plastics, Rubber and Composites, Vol. 40, Iss. 9, 2011-11 ,pp. : 425-432

Maney Publishing

Access to resources Recommend Favorite

Development of high value moulding compounds from recycled carbon fibres

By Turner T. A.   Warrior N. A.   Pickering S. J.  

Plastics, Rubber and Composites, Vol. 39, Iss. 3-5, 2010-06 ,pp. : 151-156

Maney Publishing

Access to resources Recommend Favorite

Dielectric flow sensing in resin transfer moulding of carbon fibre reinforced composites

By Skordos A.A.   Partridge I.K.  

Plastics, Rubber and Composites, Vol. 29, Iss. 8, 2000-08 ,pp. : 391-394

Maney Publishing

Access to resources Recommend Favorite

Comparison of height replication properties of micro-injection moulding and micro-injection–compression moulding for production of microstructures on lightguiding plates

By Shen Y. K.  

Plastics, Rubber and Composites, Vol. 36, Iss. 2, 2007-03 ,pp. : 77-84

Maney Publishing

Access to resources Recommend Favorite