Fibre orientation structures and their effect on crack resistance of injection moulded transverse ribbed plate

Author： Hine P.J.   Duckett R.A.   Caton-Rose P.   Coates P.D.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.33, Iss.1, 2004-01, pp. : 43-53

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Glass fibre orientation within injection moulded automotive pedal: Simulation and experimental studies

By Whiteside B.R.   Coates P.D.   Hine P.J.   Duckett R.A.  

Plastics, Rubber and Composites, Vol. 29, Iss. 1, 2000-01 ,pp. : 38-45

Maney Publishing

Access to resources Recommend Favorite

Study of mouldability in gas-assisted injection moulded fibre-reinforced Nylon parts

By Chen S.-C.   Chien R.D.   Chen Y.-C.   Teng M.-Y.  

Plastics, Rubber and Composites, Vol. 33, Iss. 2-3, 2004-03 ,pp. : 113-119

Maney Publishing

Access to resources Recommend Favorite

Does fountain flow influence molecular orientation in injection moulded parts?

By Nguyen-Chung T.   Mennig G.  

Plastics, Rubber and Composites, Vol. 35, Iss. 10, 2006-12 ,pp. : 418-424

Maney Publishing

Access to resources Recommend Favorite

Fibre orientation of fibre-reinforced PBT composites in injection moulding

By Fung C.-P.  

Plastics, Rubber and Composites, Vol. 33, Iss. 4, 2004-05 ,pp. : 170-176

Maney Publishing

Access to resources Recommend Favorite

Effect of cavity pressure on crosslink density of injection moulded silicone rubber

By Barbaroux M.   Régnier G.   Verdu J.  

Plastics, Rubber and Composites, Vol. 29, Iss. 5, 2000-05 ,pp. : 229-234

Maney Publishing

Access to resources Recommend Favorite