Physically based dynamic model for control of cavity pressure in injection moulding of amorphous plastics

By Rafizadeh M.   Patterson W.I.   Kamal M.R.  

Plastics, Rubber and Composites, Vol. 28, Iss. 2, 1999-02 ,pp. : 47-61

Maney Publishing

Access to resources Recommend Favorite

Mould fouling of elastomers during injection moulding

By Hornsby P. R.   Singh I.   Daley J. R.   Firth J.  

Plastics, Rubber and Composites, Vol. 35, Iss. 8, 2006-10 ,pp. : 331-339

Maney Publishing

Access to resources Recommend Favorite

Optimisation of continuous and pulsed cooling in injection moulding processes

By Smith A. G.   Wrobel L. C.   McCalla B. A.   Allan P. S.   Hornsby P. R.  

Plastics, Rubber and Composites, Vol. 36, Iss. 3, 2007-04 ,pp. : 93-100

Maney Publishing

Access to resources Recommend Favorite

Flow visualisation of water assisted injection moulding process

By Wu Y.-C.   Liu S.-J.  

Plastics, Rubber and Composites, Vol. 34, Iss. 5-6, 2005-06 ,pp. : 227-231

Maney Publishing

Access to resources Recommend Favorite

Developments in cryogenic gas assisted injection moulding

By Smith G. F.   Magalhaes R.  

Plastics, Rubber and Composites, Vol. 34, Iss. 5-6, 2005-06 ,pp. : 247-253

Maney Publishing

Access to resources Recommend Favorite