Sintering parameters and mechanical properties of injection moulded aluminium powder

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.54, Iss.3, 2011-07, pp. : 427-431

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Formation of aluminium nitride during sintering of powder injection moulded aluminium

By Kent D. Qian M. Schaffer G. B.

Powder Metallurgy, Vol. 53, Iss. 2, 2010-06 ,pp. : 118-124

Maney Publishing

Access to resources Recommend Favorite

Effect of sintering parameters on mechanical properties of injection moulded Ti–6Al–4V alloys

By Ergül E. Özkan Gülsoy H. Günay V.

Powder Metallurgy, Vol. 52, Iss. 1, 2009-03 ,pp. : 65-71

Maney Publishing

Access to resources Recommend Favorite

Spark plasma sintering of pure aluminium powder: mechanical properties and fracture analysis

By Zadra M. Casari F. Girardini L. Molinari A.

Powder Metallurgy, Vol. 50, Iss. 1, 2007-03 ,pp. : 40-45

Maney Publishing

Access to resources Recommend Favorite

Microstructural and mechanical properties of injection moulded gas and water atomised 17-4 PH stainless steel powder

By Gülsoy H. Ö. Özbek S. Baykara T.

Powder Metallurgy, Vol. 50, Iss. 2, 2007-06 ,pp. : 120-126

Maney Publishing

Access to resources Recommend Favorite

Microstructure and mechanical properties of injection moulded Nimonic-90 superalloy parts

By Özgün Ö Gülsoy H Ö Findik F Yilmaz R

Powder Metallurgy, Vol. 55, Iss. 5, 2012-12 ,pp. : 405-414

Maney Publishing

Access to resources Recommend Favorite