Flank wears Simulation by using back propagation neural network when cutting hardened H-13 steel in CNC End Milling

Publisher： IOP Publishing

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.53, Iss.1, 2013-12, pp. : 708-715

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Investigation of the effect of cutting speed on the Surface Roughness parameters in CNC End Milling using Artificial Neural Network

By  

IOP Conference Series: Materials Science and Engineering, Vol. 53, Iss. 1, 2013-12 ,pp. : 716-727

IOP Publishing

Access to resources Recommend Favorite

Cutting Force in High-Speed Face Milling AISI H13 Steel

By  

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 35-40

Trans Tech Publications

Access to resources Recommend Favorite

Prediction of Contact Fatigue Life of Alloy Cast Steel Rolls Using Back-Propagation Neural Network

By Jin Huijin   Wu Sujun   Peng Yuncheng  

Journal of Materials Engineering and Performance, Vol. 22, Iss. 12, 2013-12 ,pp. : 3631-3638

Springer Publishing Company

Access to resources Recommend Favorite

Wear Mechanisms of Ceramic Cutting Tool when Cutting Hardened Steel Rolls

By  

Key Engineering Materials, Vol. 2016, Iss. 703, 2016-09 ,pp. : 44-48

Trans Tech Publications

Access to resources Recommend Favorite

Machinability of hardened steel using alumina based ceramic cutting tools

By Senthil Kumar A.   Raja Durai A.   Sornakumar T.  

International Journal of Refractory and Hard Metals, Vol. 21, Iss. 3, 2003-03 ,pp. : 109-117

Elsevier

Access to resources Recommend Favorite