Developing an experimental case in aluminium foils 1100 to determine the maximum angle of formability in a piece by Dieless-SPIF process

Publisher： IOP Publishing

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.65, Iss.1, 2014-07, pp. : 210-218

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Effect of Heating to the Formability of Titanium Sheet by SPIF Technology

By  

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 171-177

Trans Tech Publications

Access to resources Recommend Favorite

Formability Discussion in Dieless Drawing of Stainless Steel Tubes

By  

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 10-15

Trans Tech Publications

Access to resources Recommend Favorite

Influence of weld geometry and mismatch on formability of aluminium tailor welded blanks: numerical and experimental analysis

By Leitao C   Zhang BK   Padmanabhan R   Rodrigues DM  

Science and Technology of Welding & Joining, Vol. 16, Iss. 8, 2011-11 ,pp. : 662-668

Maney Publishing

Access to resources Recommend Favorite

Squeeze casting of aluminium alloys for higher formability in cold forging

By Tong K. K.   Chua B. W.   Muramatsu T.   Danno A.   Yong M. S.  

International Journal of Cast Metals Research, Vol. 21, Iss. 1-4, 2008-08 ,pp. : 139-143

Maney Publishing

Access to resources Recommend Favorite

Fabrication of aluminium foam through pressure assisted high frequency induction heated sintering dissolution process: an experimental observation

By Mustapha M   Mustapha F   Mamat O   Hussain P  

Powder Metallurgy, Vol. 54, Iss. 3, 2011-07 ,pp. : 343-353

Maney Publishing

Access to resources Recommend Favorite