Influence of Cooling Rate on Fatigue Behaviour of Eutectic Al-Si (A413) Alloy Casting

E-ISSN： 1662-7482|2015|787|490-494

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.787, 2015-09, pp. : 490-494

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Tribological Behaviour of SiC Particle Reinforced Al-Si Alloy

By Kaur Kamalpreet

Tribology Letters, Vol. 44, Iss. 1, 2011-10 ,pp. : 41-58

Springer Publishing Company

Access to resources Recommend Favorite

Effect Pouring Temperature on Casting Defect Susceptibility of Hot Tearing in Metal Alloy Al-Si

Applied Mechanics and Materials, Vol. 2015, Iss. 758, 2015-05 ,pp. : 95-99

Trans Tech Publications

Access to resources Recommend Favorite

Wear and Mechanical Behaviour of Hypo-Eutectic Al-7%Si-0.5%Mg Alloy (A357) Reinforced with Al₂O₃ Particles

Applied Mechanics and Materials, Vol. 2016, Iss. 829, 2016-05 ,pp. : 66-72

Trans Tech Publications

Access to resources Recommend Favorite

Dry Sliding Wear Behavior of Zircon Sand Reinforced Al–Si Alloy

By Kaur Kamalpreet

Tribology Letters, Vol. 38, Iss. 3, 2010-06 ,pp. : 377-387

Springer Publishing Company

Access to resources Recommend Favorite

The Numerical Simulation of Reinforced Particle Stress Concentration in Al-Si Alloy Rolling

Applied Mechanics and Materials, Vol. 2015, Iss. 719, 2015-02 ,pp. : 55-58

Trans Tech Publications

Access to resources Recommend Favorite