Experimental Analysis and Forecasting of Material Removal Rate and Cutting Force in End Milling on A356 Alloy-SiC Metal Matrix Composites

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|787|637-642

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.787, 2015-09, pp. : 637-642

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of SiCp Reinforcement on Machinability of A356 Alloy Metal Matrix Composites

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 142-148

Trans Tech Publications

Access to resources Recommend Favorite

Roughness Analysis of the Holes Drilled on Al / SiC Metal Matrix Composites Using Atomic Force Microscope

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 837-843

Trans Tech Publications

Access to resources Recommend Favorite

Tribological Behaviour of Hybrid (Al356 + SiC + Gr) Metal Matrix Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 269-275

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Research of Effective Cutting Speed Influence on Surface Roughness in Ball End Milling of C45 Material with Hardness 54 HRC

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 27-32

Trans Tech Publications

Access to resources Recommend Favorite

Monitoring of Surface Roughness Based on Cutting Force and Cutting Temperature in Ball-End Milling Process by Utilizing Response Surface Analysis

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 324-328

Trans Tech Publications

Access to resources Recommend Favorite