Automatic Recognition of Multi-Axis Machining Features Based on Machining Process from 3D Solid Model

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|789|873-877

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.789, 2015-10, pp. : 873-877

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Recognition of Machining Features Based on Identification of Inner/Outer Loops on Basic Face

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 834, 2016-05 ,pp. : 9-14

Trans Tech Publications

Access to resources Recommend Favorite

Machining Simulation for Centrifugal Impeller Based on Modelling of Five-Axis Machining Center

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 741, 2015-04 ,pp. : 227-231

Trans Tech Publications

Access to resources Recommend Favorite

Technological Research on Information Extraction of Part Process Model Based on Machining Feature

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 696, 2015-01 ,pp. : 287-292

Trans Tech Publications

Access to resources Recommend Favorite

The Use of 3D Scanning and 5-Axis Machining in Design and Fabrication of Dental Bridge

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 834, 2016-05 ,pp. : 28-33

Trans Tech Publications

Access to resources Recommend Favorite

AXIS-BASED LOOK-AHEAD INTERPOLATOR FOR MACHINING OF SURFACES REPRESENTED BY NURBS CURVES

By Hongyao Shen   Jianzhong Fu   Zichen Chen  

Machining Science and Technology, Vol. 12, Iss. 4, 2008-10 ,pp. : 546-562

Taylor & Francis Ltd

Access to resources Recommend Favorite