Effect of Cutting Parameters on Feed Force in Machining AISI 1018 Steel

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|813|299-303

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.813, 2015-12, pp. : 299-303

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Modeling and Analysis of Cutting Force in Turning of AISI 316L Stainless Steel (SS) under Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 949-955

Trans Tech Publications

Access to resources Recommend Favorite

Optimization and Prediction of Cutting Force and Surface Roughness in End Milling Process of AISI 304 Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 362-367

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Analysis of Machining Parameters in WEDM of AISI D3 Steel Using Taguchi Method

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 343-350

Trans Tech Publications

Access to resources Recommend Favorite

DYNAMIC PROPERTIES FOR MODELING AND SIMULATION OF MACHINING: EFFECT OF PEARLITE TO AUSTENITE PHASE TRANSITION ON FLOW STRESS IN AISI 1075 STEEL

By Burns Timothy  

Machining Science and Technology, Vol. 15, Iss. 1, 2011-01 ,pp. : 1-20

Taylor & Francis Ltd

Access to resources Recommend Favorite