Research of Directional Stress Distribution on the Fully Plastic Bulged Pressure Hull

E-ISSN： 1662-8985|2014|1082|412-415

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2014, Iss.1082, 2015-02, pp. : 412-415

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study on Abutment Pressure Distribution Law of Fully-Mechanized Sublevel Caving Face in Extra-Thickness

Advanced Materials Research, Vol. 2015, Iss. 1094, 2015-04 ,pp. : 405-409

Trans Tech Publications

Access to resources Recommend Favorite

Reliability Analysis of Fully Mechanized Working Face Based on Appraisal and Distribution Method

Advanced Materials Research, Vol. 2015, Iss. 1092, 2015-04 ,pp. : 1444-1447

Trans Tech Publications

Access to resources Recommend Favorite

A technique for the fabrication of fully dense Ca-rich plagioclase (An70-An100) samples suitable for studying the plastic rheology of bytownite (An80)

By Wendt A.S. Olgaard D.L. Mainprice D.

Journal of Materials Science, Vol. 34, Iss. 23, 1999-12 ,pp. : 5733-5742

Springer Publishing Company

Access to resources Recommend Favorite

Stress Distribution in Joints in Panel Structures

Advanced Materials Research, Vol. 2015, Iss. 1124, 2015-10 ,pp. : 209-218

Trans Tech Publications

Access to resources Recommend Favorite

Three-dimensional analysis of plastic flow during high-pressure torsion

By Figueiredo Roberto

Journal of Materials Science, Vol. 48, Iss. 13, 2013-07 ,pp. : 4524-4532

Springer Publishing Company

Access to resources Recommend Favorite