Determination of Surface Roughness in Turning of Aluminum Bronze Alloy (UNS С 63020) Using Cutting Tools with Carbide Geometry Positive and Negative

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2014|805|368-373

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2014, Iss.805, 2015-01, pp. : 368-373

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Surface Roughness and Cutting Force Components Evaluation in Hard Turning by Differently Shaped Cutting Tools

By  

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 26-32

Trans Tech Publications

Access to resources Recommend Favorite

Influence of cutting parameters on surface roughness in turning glass-fibre-reinforced plastics using statistical analysis

By Davim J Paulo   Mata Francisco  

Industrial Lubrication and Tribology, Vol. 56, Iss. 5, 2004-05 ,pp. : 270-274

Emerald Group Publishing Ltd

Access to resources Recommend Favorite

Study on the Machinability Characteristics of Ti2AlNb Based Alloy in Turning with Coated Cemented Carbide Tools

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 106-111

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Laser Shot Peening Parameters on the Surface Hardness and Roughness of 7075 Aluminum Alloy

By  

Materials Science Forum, Vol. 2018, Iss. 920, 2018-05 ,pp. : 83-88

Trans Tech Publications

Access to resources Recommend Favorite

Determination of the wear coefficient of tungsten carbide by a turning operation

By Yang L.J.  

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 366-375

Elsevier

Access to resources Recommend Favorite