Numerical Analysis of Influence of Cutting Edge Radius on the Minimum Thickness of the Machined Layer

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|862|230-237

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.862, 2016-09, pp. : 230-237

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Minimum degree, edge-connectivity and radius

By Wu Baoyindureng   An Xinhui   Liu Guojie   Yan Guiying   Liu Xiaoping  

Journal of Combinatorial Optimization, Vol. 26, Iss. 3, 2013-10 ,pp. : 585-591

Springer Publishing Company

Access to resources Recommend Favorite

Finite Element Simulation of Minimum Cutting Thickness in Micro-Cutting

By  

Materials Science Forum, Vol. 2016, Iss. 861, 2016-08 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cutting Tool Edge Preparation on Cutting Force and Surface Integrity

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 250-255

Trans Tech Publications

Access to resources Recommend Favorite

Cutting Analysis of 3-Layer Laminated Plate

By  

Materials Science Forum, Vol. 2014, Iss. 804, 2015-01 ,pp. : 307-310

Trans Tech Publications

Access to resources Recommend Favorite

Influence of covering on critical thickness of strained In x Ga 1-x As layer

By Jasik A.   Kosiel K.   Strupinski W.   Wesolowski M.  

Thin Solid Films, Vol. 412, Iss. 1, 2002-06 ,pp. : 50-54

Elsevier

Access to resources Recommend Favorite