Cutting Performance of PCD Tools Improved by Ultraviolet-Ray Irradiation Polishing

E-ISSN： 1662-9752|2016|874|109-114

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.874, 2016-11, pp. : 109-114

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Mirror-Like Surface Finishing of PCD by Fixed Abrasive Polishing

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 139-144

Trans Tech Publications

Access to resources Recommend Favorite

The cutting performance and wear mechanism of ceramic cutting tools with MoS 2 coating deposited by magnetron sputtering

By Liu Y.-R. Liu J. Du Z.

Wear, Vol. 231, Iss. 2, 1999-07 ,pp. : 285-292

Elsevier

Access to resources Recommend Favorite

Effect of Cutting Speed on the Face Milling of CFRP Using a PCD Tool

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 487-491

Trans Tech Publications

Access to resources Recommend Favorite

Investigations of the wear of cubic boron nitride cutting tools using Auger electron spectroscopy and X-ray analysis by EPMA

By Zimmermann M. Lahres M. Viens D.V. Laube B.L.

Wear, Vol. 209, Iss. 1, 1997-08 ,pp. : 241-246

Elsevier

Access to resources Recommend Favorite

Surface Finishing on Arc-Shaped Inner Surface by Ultraviolet Assisted Polishing

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 133-138

Trans Tech Publications

Access to resources Recommend Favorite