Microcellular Foam Injection Molding of Thermoplastics Using Green Physical Blowing Agent

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|875|77-111

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.875, 2016-11, pp. : 77-111

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Computer Analysis of Polyolefins Produced with Injection Molding Process Using Physical Blowing Agents

By  

Materials Science Forum, Vol. 2018, Iss. 919, 2018-05 ,pp. : 299-306

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Simulation of Injection Molding using OpenFOAM

By  

PROCEEDINGS IN APPLIED MATHEMATICS & MECHANICS (ELECTRONIC), Vol. 14, Iss. 1, 2014-12 ,pp. : 673-674

John Wiley & Sons Inc

Access to resources Recommend Favorite

Morphological analysis of microcellular PP produced in a core‐back injection process using chemical blowing agents and gas counter pressure

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. : 2465-2473

John Wiley & Sons Inc

Access to resources Recommend Favorite

Morphological analysis of microcellular PP produced in a core‐back injection process using chemical blowing agents and gas counter pressure

By  

POLYMER ENGINEERING & SCIENCE, Vol. 55, Iss. 11, 2015-11 ,pp. : 2465-2473

John Wiley & Sons Inc

Access to resources Recommend Favorite

Fabrication of highly expanded thermoplastic polyurethane foams using microcellular injection molding and gas‐laden pellets

By  

POLYMER ENGINEERING & SCIENCE, Vol. 32-3888, Iss. 11, 2015-11 ,pp. : 2643-2652

John Wiley & Sons Inc

Access to resources Recommend Favorite