Granulation of Extruded Plastic Wires: Influence of Tool Coating Properties and Tool Geometry on Cutting Forces and Tool Wear

Publisher： Trans Tech Publications

E-ISSN： 1662-8985|2016|1140|181-188

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2016, Iss.1140, 2016-10, pp. : 181-188

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Tool Wear Mechanism in Interrupted Cutting Conditions

By Sayit Ercan  

Materials and Manufacturing Processes, Vol. 24, Iss. 4, 2009-04 ,pp. : 476-483

Taylor & Francis Ltd

Access to resources Recommend Favorite

Optimization of Tool Geometry and Cutting Parameters for Hard Turning

By Singh Dilbag   Rao P. Venkateswara  

Materials and Manufacturing Processes, Vol. 22, Iss. 1, 2007-01 ,pp. : 15-21

Taylor & Francis Ltd

Access to resources Recommend Favorite

Influence of Dressing Tool Specification on Dressing Tool Wear for Generating Gear Grinding

By  

Advanced Materials Research, Vol. 2016, Iss. 1140, 2016-10 ,pp. : 228-235

Trans Tech Publications

Access to resources Recommend Favorite

Improving Tool Wear Resistance in Inconel 718 Cutting by Considering Surface Microstructures of CBN Cutting Tool

By  

Advanced Materials Research, Vol. 2015, Iss. 806, 2015-12 ,pp. : 561-566

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Analysis of the Stressed State and Evaluation of Strength of a Cutting Tool with Thin Coating

By Oleinikov A.I.   Kuz'min A.O.  

Strength of Materials, Vol. 35, Iss. 1, 2003-01 ,pp. : 68-77

Springer Publishing Company

Access to resources Recommend Favorite