Effects of Low Temperature and High Strain Rate on the Tensile Behaviors of High-Performance Energetic Composite

E-ISSN： 2261-236x|67|issue|06013-06013

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.67, Iss.issue, 2016-07, pp. : 06013-06013

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

To further study the effects of low temperature and high strain rate on the tensile behaviors of hydroxyl-terminated polybutadiene (HTPB) propellant, an INSTRON testing machine was applied for carrying out the uniaxial tensile tests at low temperatures and room temperature after storage at low temperatures. The strain rates are in the range of 0.40 to 85.71 s⁻¹. Scanning electron microscope (SEM) was used for examining the failure mechanisms of HTPB propellant under the test conditions. The results reveal that HTPB propellant is still capable of large deformation at lower strain rates and low temperatures in the glass transition and glass state. The characteristics of stress-strain curves at room temperature after storage at low temperatures are the same with that directly obtained at room temperature. The effect of strain rate on the elastic modulus E at various temperatures is almost the same. However, the effect of strain rate on the maximum tensile stress σ_m becomes weak with decreasing temperature. Furthermore, the strain ε_m is nearly independence of the strain rate at higher strain rates and the lowest test temperature in glass state. Continuously decreasing temperature can more easily cause the extensive brittle fracture of AP particles, even at lower strain rates. The temperature changes from room temperature to low temperature and then from low temperature to room temperature in a short time cannot influence the failure mechanism of HTPB propellant at room temperature and high strain rate.