Power Rating and Tools Wear in Milling of Hardened SAE 4340 Steel with Minimum Quantity of Fluid (MQF)

E-ISSN： 1662-9795|2017|735|24-28

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.735, 2017-06, pp. : 24-28

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Tool Wear of Aluminum/Chromium/Tungsten/Silicon-Based-Coated End Mill Cutters in Milling Hardened Steel

Solid State Phenomena, Vol. 2017, Iss. 263, 2017-10 ,pp. : 85-89

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Micro-Milling of Hardened Tool Steel

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 57-62

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Micro-Machinability of Hardened Tool Steel in Profile Micro-Milling

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 85-92

Trans Tech Publications

Access to resources Recommend Favorite

Wear Mechanisms of Ceramic Cutting Tool when Cutting Hardened Steel Rolls

Key Engineering Materials, Vol. 2016, Iss. 703, 2016-09 ,pp. : 44-48

Trans Tech Publications

Access to resources Recommend Favorite

Machinability of hardened steel using alumina based ceramic cutting tools

By Senthil Kumar A. Raja Durai A. Sornakumar T.

International Journal of Refractory and Hard Metals, Vol. 21, Iss. 3, 2003-03 ,pp. : 109-117

Elsevier

Access to resources Recommend Favorite