Difference of Feed Marks in Cutting Fluids when Turning Stainless Steel

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2017|749|111-117

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2017, Iss.749, 2017-09, pp. : 111-117

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Stability of Adhered Material to the Cutting Edge of a Cermet Insert in Turning of an Austenitic Stainless Steel

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 363-368

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Various Cutting Fluids on Energy Consumption during Turning

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 252-256

Trans Tech Publications

Access to resources Recommend Favorite

Caution Is Advised When Specifying Stainless Steel Fasteners

By Pepi M.  

Journal of Failure Analysis & Prevention, Vol. 5, Iss. 1, 2005-02 ,pp. : 72-78

Springer Publishing Company

Access to resources Recommend Favorite

Wear Mechanisms of Ceramic Cutting Tool when Cutting Hardened Steel Rolls

By  

Key Engineering Materials, Vol. 2016, Iss. 703, 2016-09 ,pp. : 44-48

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Cutting Tools Durability Importance in Turning Process of Steel C60

By  

Key Engineering Materials, Vol. 2015, Iss. 669, 2016-02 ,pp. : 319-326

Trans Tech Publications

Access to resources Recommend Favorite