Effect of Cutting Feed and Chip Size Ratio on Cutting Force

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2017|261|3-8

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2017, Iss.261, 2017-09, pp. : 3-8

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Cutting Force Control on Cutting Characteristics of CFRP in Diamond Saw Cutting

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 214-219

Trans Tech Publications

Access to resources Recommend Favorite

Size Effect in Machining on Initial Tool Wear in Heat-Resistant Alloy Cutting

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 357-362

Trans Tech Publications

Access to resources Recommend Favorite

Effect of cutting parameters on cutting force and surface roughness in milling alumina reinforced Al-6Zn-2Mg-2Cu composites

By Übeyli M   Acır A   Keleş Ö   Akçay C E  

Powder Metallurgy, Vol. 54, Iss. 2, 2011-04 ,pp. : 172-176

Maney Publishing

Access to resources Recommend Favorite

The Effect of Cutting Force Vibration on Machining Quality for Reaming ZL102 Alloy with PCD Step Reamer

By  

Key Engineering Materials, Vol. 2018, Iss. 764, 2018-03 ,pp. : 279-290

Trans Tech Publications

Access to resources Recommend Favorite

Research on Cutting Force of Corner Milling of Inclined Plane

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 856-862

Trans Tech Publications

Access to resources Recommend Favorite