Evaluation of Process Parameters in Machining of AA6063 Alloy

E-ISSN： 1662-8985|2018|1148|109-114

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2018, Iss.1148, 2018-08, pp. : 109-114

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influences of Varying Current by Tungsten Inert Gas Welding and its Process Parameters on Weld Quality of AA 6061 Aluminium Alloy

Advanced Materials Research, Vol. 2018, Iss. 1148, 2018-08 ,pp. : 136-141

Trans Tech Publications

Access to resources Recommend Favorite

Study on FSW Butt Joint Properties of Dissimilar Wrought AA6063-T1 Aluminum Alloy and Cast Al-Mg Aluminum Alloy

Key Engineering Materials, Vol. 2018, Iss. 789, 2018-12 ,pp. : 115-119

Trans Tech Publications

Access to resources Recommend Favorite

Influence of cutting parameters on surface quality when machining a CoCrWNi alloy

MATEC Web of conference, Vol. 178, Iss. issue, 2018-07 ,pp. : 01009-01009

Edp Sciences

Access to resources Recommend Favorite

Process Parameter Optimization for Abrasive Water Jet Machining of Titanium Alloy Using Meta-Heuristic Algorithms

MATEC Web of conference, Vol. 221, Iss. issue, 2018-10 ,pp. : 01004-01004

Edp Sciences

Access to resources Recommend Favorite

Research on Correlation Analysis between Process Parameters of NC Machining and Quality Data Based on Grey Relational Analysis

MATEC Web of conference, Vol. 175, Iss. issue, 2018-07 ,pp. : 03053-03053

Edp Sciences

Access to resources Recommend Favorite