Multi objective optimization for kerf and material removal rate in wire electrical discharge machining using Taguchi method combined grey relational analysis

Publisher： Edp Sciences

E-ISSN： 2261-236x|204|issue|06006-06006

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.204, Iss.issue, 2018-09, pp. : 06006-06006

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Optimization of WEDM process during machining of Al-Al2O3 composite using Taguchi based Grey Relational Analysis

By  

MATEC Web of conference, Vol. 172, Iss. issue, 2018-06 ,pp. : 04008-04008

Edp Sciences

Access to resources Recommend Favorite

Development of Multi-Objective Prediction Model for Wire Electrical Discharge Machining of Inconel 718 Nickel-Based Superalloy

By  

Key Engineering Materials, Vol. 2018, Iss. 789, 2018-12 ,pp. : 37-44

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of electric discharge machining parameters on titanium alloy (ti-6al-4v) using Taguchi parametric design and genetic algorithm

By  

MATEC Web of conference, Vol. 172, Iss. issue, 2018-06 ,pp. : 04007-04007

Edp Sciences

Access to resources Recommend Favorite

Optimization of Molding Parameters Using Taguchi Method to Increase the Electrical Conductivity and Tensile Strength of Conductive Polymer Composites

By  

MATEC Web of conference, Vol. 221, Iss. issue, 2018-10 ,pp. : 01001-01001

Edp Sciences

Access to resources Recommend Favorite

Research on Correlation Analysis between Process Parameters of NC Machining and Quality Data Based on Grey Relational Analysis

By  

MATEC Web of conference, Vol. 175, Iss. issue, 2018-07 ,pp. : 03053-03053

Edp Sciences

Access to resources Recommend Favorite