Modeling and Analysis of Cutting Force in Turning of AISI 316L Stainless Steel (SS) under Nano Cutting Environment

E-ISSN： 1662-7482|2015|766|949-955

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.766, 2015-07, pp. : 949-955

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Optimization and Prediction of Cutting Force and Surface Roughness in End Milling Process of AISI 304 Stainless Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 362-367

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cutting Parameters on Feed Force in Machining AISI 1018 Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 299-303

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Electroplastic Effect in AISI 316L Austenitic Stainless Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 792, 2015-10 ,pp. : 568-571

Trans Tech Publications

Access to resources Recommend Favorite

Taguchi Approach for the Optimization of Cutting Parameters in Finish Turning of Medical Stainless Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 153-158

Trans Tech Publications

Access to resources Recommend Favorite