Heat-Assisted Machining for Material Removal Improvement

Publisher： IOP Publishing

E-ISSN： 1757-899X|88|1|377-381

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.88, Iss.1, 2015-09, pp. : 377-381

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructure Control of L1 0 -Ordered FePt Granular Film for Heat-Assisted Magnetic Recording (HAMR) Media

By Varaprasad B.  

JOM, Vol. 65, Iss. 7, 2013-07 ,pp. : 853-861

Springer Publishing Company

Access to resources Recommend Favorite

Material Removal Rate, Kerf, and Surface Roughness of Tungsten Carbide Machined with Wire Electrical Discharge Machining

By Shah Aqueel   Mufti Nadeem   Rakwal Dinesh   Bamberg Eberhard  

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 71-76

Springer Publishing Company

Access to resources Recommend Favorite

Material Removal Rate Control in Open-Air Type Plasma Chemical Vaporization Machining by Pulse Width Modulation of Applied Power

By  

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 593-596

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Effects of Cutting Parameters of Wire Electrical Discharge Machining on Material Removal Rate and Surface Integrity

By  

IOP Conference Series: Materials Science and Engineering, Vol. 115, Iss. 1, 2016-02 ,pp. : 120-126

IOP Publishing

Access to resources Recommend Favorite

Research of the Basic Physical Regularities of Material Removal in Electrical Discharge Machining of Tool Steel

By  

Key Engineering Materials, Vol. 2017, Iss. 756, 2017-10 ,pp. : 96-106

Trans Tech Publications

Access to resources Recommend Favorite