Cutting Temperature and Cutting Forces Investigation Based on the Taguchi Design Method when High-Speed Milling of Titanium Matrix Composites with PCD Tool

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|836|168-174

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.836, 2016-02, pp. : 168-174

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Cutting Speed on the Face Milling of CFRP Using a PCD Tool

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 487-491

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Variable Pitch on Cutting Temperature, Cutting Forces and Surface Roughness Using Nitico30 Cutting Tool when End Milling of Stainless Steel 316L

By  

Materials Science Forum, Vol. 2017, Iss. 909, 2017-12 ,pp. : 50-55

Trans Tech Publications

Access to resources Recommend Favorite

An Evaluation Method Based on Grey Relational Grade for Cutting Tool Performance in the Milling of Titanium Aircraft Components

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 270-276

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Cutting Atmosphere on High-Speed End Milling Process for Titanium Alloy Ti6Al4V

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 46-51

Trans Tech Publications

Access to resources Recommend Favorite

Parameters Optimization Research of High-Speed Milling PM60 Mould Steel Based on Taguchi Method

By  

Materials Science Forum, Vol. 2016, Iss. 861, 2016-08 ,pp. : 75-83

Trans Tech Publications

Access to resources Recommend Favorite