Publisher： Elsevier
ISSN： 1364-5439
Source： Focus on Powder Coatings, Vol.2002, Iss.8, 2002-08, pp. : 4-5
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
By Lin Jing Wang Wei Wen Xiufang Cai Zhi-Qi Pi Pihui Zheng Da-feng Cheng Jiang Yang Zhuoru
Pigment & Resin Technology, Vol. 41, Iss. 6, 2012-11 ,pp. :
Access to resources
Recommend
Smart 'in mould' manipulation of materials
By Smith G. F. Goodship V. Ogur E. O. Stidworthy P.
Plastics, Rubber and Composites, Vol. 37, Iss. 2-4, 2008-05 ,pp. :
Surface Coatings International Part B: Coatings Transactions, Vol. 89, Iss. 2, 2006-06 ,pp. :
Mould fouling of elastomers during injection moulding
By Hornsby P. R. Singh I. Daley J. R. Firth J.
Plastics, Rubber and Composites, Vol. 35, Iss. 8, 2006-10 ,pp. :
Algorithm to optimise number of gates and locations in an injection mould
Plastics, Rubber and Composites, Vol. 33, Iss. 8, 2004-10 ,pp. :