A case study comparing 1-D and 3-D analytical modeling methods for vehicle intake system design

Author： Aubert Allan   Green Edward L.   Bastiaan Jennifer   Leclercq Thomas  

Publisher： Institute of Noise Control Engineering

ISSN： 0736-2935

Source： INTER-NOISE and NOISE-CON Congress and Conference Proceedings, Vol.2005, Iss.2, 2005-10, pp. : 503-508

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

LIMITING SOLIDS FLUX ANALYSIS: A STUDY CASE COMPARING 1-D AND 2-D MODELS

By       Alex J.  

Proceedings of the Water Environment Federation, Vol. 2005, Iss. 13, 2005-01 ,pp. : 2562-2584

Water Environment Federation

Access to resources Recommend Favorite

Numerical simulation of air intake system orifice noise using 1D modeling

By Arruda Fabio R.   Zavala Paulo  

INTER-NOISE and NOISE-CON Congress and Conference Proceedings, Vol. 2005, Iss. 4, 2005-07 ,pp. : 4120-4126

Institute of Noise Control Engineering

Access to resources Recommend Favorite

The research of 1D / 3D coupling simulation on pump and pipe system

By  

IOP Conference Series: Earth and Environmental Science, Vol. 15, Iss. 5, 2012-11 ,pp. : 231-239

IOP Publishing

Access to resources Recommend Favorite

3D modeling design and engineering analysis of automotive suspension beam

By  

MATEC Web of conference, Vol. 63, Iss. issue, 2016-07 ,pp. : 02023-02023

Edp Sciences

Access to resources Recommend Favorite

Spatial Data Structure and Functionalities for 3D Land Management System Implementation: Israel Case Study

By Jaljolie Ruba   van Oosterom Peter   Dalyot Sagi  

ISPRS International Journal of Geo-Information, Vol. 7, Iss. 1, 2018-01 ,pp. : 10-10

MDPI

Access to resources Recommend Favorite