New aspects of process induced properties of microinjection moulded parts

Author： Jungmeier A.   Ehrenstein G. W.   Drummer D.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.39, Iss.7, 2010-09, pp. : 308-314

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Morphology of microinjection moulded polyoxymethylene

By Kamal M. R.   Chu J.   Derdouri S.   Hrymak A.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 332-341

Maney Publishing

Access to resources Recommend Favorite

Experimental investigation and numerical simulation of cooling process in water assisted injection moulded parts

By Liu S.-J.   Chen W.-K.  

Plastics, Rubber and Composites, Vol. 33, Iss. 6, 2004-08 ,pp. : 260-266

Maney Publishing

Access to resources Recommend Favorite

Optimisation of bubble size in qc rotationally moulded parts

By Liu S-J.   Chen C-F.  

Plastics, Rubber and Composites, Vol. 29, Iss. 8, 2000-08 ,pp. : 411-416

Maney Publishing

Access to resources Recommend Favorite

Properties of compression moulded new fully biobased thermoset composites with aligned flax fibre textiles

By Pohl Th   Bierer M   Natter E   Madsen B   Hoydonckx H   Schledjewski R  

Plastics, Rubber and Composites, Vol. 40, Iss. 6-7, 2011-09 ,pp. : 294-299

Maney Publishing

Access to resources Recommend Favorite

Does fountain flow influence molecular orientation in injection moulded parts?

By Nguyen-Chung T.   Mennig G.  

Plastics, Rubber and Composites, Vol. 35, Iss. 10, 2006-12 ,pp. : 418-424

Maney Publishing

Access to resources Recommend Favorite