Comparison of height replication properties of micro-injection moulding and micro-injection–compression moulding for production of microstructures on lightguiding plates

By Shen Y. K.  

Plastics, Rubber and Composites, Vol. 36, Iss. 2, 2007-03 ,pp. : 77-84

Maney Publishing

Access to resources Recommend Favorite

Enhancement of surface replication by gas assisted microinjection moulding

By Yoon S.-H.   Lee K.-H.   Palanisamy P.   Lee J. S.   Cha N.-G.   Carter D. J.   Mead J. L.   Barry C. M. F.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 293-299

Maney Publishing

Access to resources Recommend Favorite

Effect of processing conditions on shrinkage and warpage and morphology of injection moulded parts using microcellular injection moulding

By Kramschuster A.   Cavitt R.   Ermer D.   Chen Z. B.   Turng L.-S.  

Plastics, Rubber and Composites, Vol. 35, Iss. 5, 2006-06 ,pp. : 198-209

Maney Publishing

Access to resources Recommend Favorite

Improving weldline strengths of injection moulded parts by ultrasonic oscillation

By Liu S.-J.   Lin K.-Y.   Tsai S.-K.  

Plastics, Rubber and Composites, Vol. 37, Iss. 1, 2008-02 ,pp. : 23-28

Maney Publishing

Access to resources Recommend Favorite

Effect of moulding conditions on the tensile strength of cyclic olefin copolymers (COC) injection moulded parts

By Chien R.-D.   Chen C.-S.   Chen S.-C.  

Plastics, Rubber and Composites, Vol. 34, Iss. 2, 2005-03 ,pp. : 70-75

Maney Publishing

Access to resources Recommend Favorite