Two-component microinjection moulding for MID fabrication

Author： Islam A.   Hansen H. N.   Tang P. T.   Jørgensen M. B.   Ørts S. F.  

Publisher： Maney Publishing

ISSN： 1743-2898

Source： Plastics, Rubber and Composites, Vol.39, Iss.7, 2010-09, pp. : 300-307

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Two-component water assisted injection moulding

By Lang S.   Parkinson M. J.  

Plastics, Rubber and Composites, Vol. 34, Iss. 5-6, 2005-06 ,pp. : 232-235

Maney Publishing

Access to resources Recommend Favorite

Microinjection moulding of polymers

By Coulter John  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 285-285

Maney Publishing

Access to resources Recommend Favorite

One- and two-component micro powder injection moulding derived from thermoplastic microreplication

By Piotter V.   Mueller T.   Plewa K.   Ritzhaupt-Kleissl H.-J.   Ruh A.   Hausselt J.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 287-292

Maney Publishing

Access to resources Recommend Favorite

Enhancement of surface replication by gas assisted microinjection moulding

By Yoon S.-H.   Lee K.-H.   Palanisamy P.   Lee J. S.   Cha N.-G.   Carter D. J.   Mead J. L.   Barry C. M. F.  

Plastics, Rubber and Composites, Vol. 39, Iss. 7, 2010-09 ,pp. : 293-299

Maney Publishing

Access to resources Recommend Favorite

Multi-component laminate moulding (MLM)

By Allan P. S.  

Plastics, Rubber and Composites, Vol. 34, Iss. 5-6, 2005-06 ,pp. : 254-258

Maney Publishing

Access to resources Recommend Favorite