Interface Controlled Decarburisation Model for Injection Moulded Parts During Debinding

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.40, Iss.1, 1997-01, pp. : 66-72

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Dilatometric analysis of thermal debinding of injection moulded iron compacts

By Hu S.C. Hwang K.S.

Powder Metallurgy, Vol. 43, Iss. 3, 2000-03 ,pp. : 239-244

Maney Publishing

Access to resources Recommend Favorite

Solvent debinding kinetics and sintered properties of injection moulded 316L stainless steel powder

By Eroglu S. Bakan H. I.

Powder Metallurgy, Vol. 48, Iss. 4, 2005-12 ,pp. : 329-332

Maney Publishing

Access to resources Recommend Favorite

In situ dimensional change, mass loss and mechanisms for solvent debinding of powder injection moulded components

By Westcot E. J. Binet Andrandall C. German M.

Powder Metallurgy, Vol. 46, Iss. 1, 2003-04 ,pp. : 61-67

Maney Publishing

Access to resources Recommend Favorite

Microstructure and mechanical properties of injection moulded Nimonic-90 superalloy parts

By Özgün Ö Gülsoy H Ö Findik F Yilmaz R

Powder Metallurgy, Vol. 55, Iss. 5, 2012-12 ,pp. : 405-414

Maney Publishing

Access to resources Recommend Favorite

Length Change and Deformation of Powder Injection–Molded Compacts during Solvent Debinding

By Hu S.C. Hwang K.S.

Metallurgical and Materials Transactions A, Vol. 31, Iss. 5, 2000-05 ,pp. : 1473-1478

Springer Publishing Company

Access to resources Recommend Favorite