Comparison of high performance PM gears manufactured by conventional and warm compaction and surface densification

Author： Fordén Linnéa Bengtsson Sven Bergström Magnus

ISSN： 1743-2901

Source： Powder Metallurgy, Vol.48, Iss.1, 2005-03, pp. : 10-12

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Finite element modelling of PM surface densification process

By Yazici B. A. Kraft T. Riedel H.

Powder Metallurgy, Vol. 51, Iss. 3, 2008-09 ,pp. : 211-216

Maney Publishing

Access to resources Recommend Favorite

Wear Mechanism and Cutting Performance of Conventional and High-Strength PM High-Speed Steels

By Hellman P.

Powder Metallurgy, Vol. 25, Iss. 2, 1982-01 ,pp. : 79-84

Maney Publishing

Access to resources Recommend Favorite

A Comparison of Mechanical Properties of Lumbar Bilateral Implants Manufactured by Additive and Conventional Technologies

Key Engineering Materials, Vol. 2014, Iss. 635, 2015-02 ,pp. : 139-142

Trans Tech Publications

Access to resources Recommend Favorite

Electroimpact Compaction of PM Components

By Alp T. Can M. Al-Hassani S. T. S.

Powder Metallurgy, Vol. 30, Iss. 1, 1987-01 ,pp. : 29-36

Maney Publishing

Access to resources Recommend Favorite

Bending Fatigue Analysis of PM Gears

Key Engineering Materials, Vol. 2017, Iss. 754, 2017-10 ,pp. : 299-302

Trans Tech Publications

Access to resources Recommend Favorite