Related content

Taguchi method based optimization of cutting tool flank wear during turning of PR-Al/20vol.% SiC-MMC

By Manna Alakesh   Bhattacharyya Bijay  

International Journal of Machining and Machinability of Materials, Vol. 1, Iss. 4, 2007-02 ,pp. : 488-499

Inderscience Publishers

Access to resources Recommend Favorite

Modelling and optimisation of tool acceleration, surface roughness, acoustic emission and flank wear during turning of Al-Si-SiC composite

By Sharma Vishal S.   Chandrashekara K.   Dogra Manu  

International Journal of Machining and Machinability of Materials, Vol. 9, Iss. 1-2, 2011-01 ,pp. : 131-148

Inderscience Publishers

Access to resources Recommend Favorite

Optimum selection of abrasive flow machining conditions during fine finishing of Al/15 wt% SiC-MMC using Taguchi method

By Mali Harlal   Manna Alakesh  

The International Journal of Advanced Manufacturing Technology, Vol. 50, Iss. 9-12, 2010-10 ,pp. : 1013-1024

Springer Publishing Company

Access to resources Recommend Favorite

Multi-response optimisation of machining parameters during drilling LM6Mg15SiC-Al-MMC based on Grey relational analysis

By Manna Alakesh  

International Journal of Machining and Machinability of Materials, Vol. 14, Iss. 3, 2013-09 ,pp. : 275-294

Inderscience Publishers

Access to resources Recommend Favorite

Optimal cutting parameters estimation to improve surface finish in turning operation in AISI 1045 using Taguchi's robust design

By Babu V. Suresh   Amuthakkannan Rajakannu   Kumar S. Sriram   Muruganandam A.  

International Journal of Industrial and Systems Engineering, Vol. 15, Iss. 1, 2013-07 ,pp. : 19-36

Inderscience Publishers

Access to resources Recommend Favorite