Experimental research of cutting forces during microgrinding

E-ISSN： 2261-236x|224|issue|01049-01049

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.224, Iss.issue, 2018-10, pp. : 01049-01049

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental evaluation of the influence of tool wear on the temperature in the cutting zone during the turning of metals

MATEC Web of conference, Vol. 226, Iss. issue, 2018-11 ,pp. : 02011-02011

Edp Sciences

Access to resources Recommend Favorite

Modelling and Optimization for Cutting Forces in Ultrasonic-Assisted Drilling of Soda Glass

Key Engineering Materials, Vol. 2018, Iss. 775, 2018-09 ,pp. : 487-492

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of chip formation and cutting forces in end milling AISI D2 tool steel with different cutting tool geometries

MATEC Web of conference, Vol. 178, Iss. issue, 2018-07 ,pp. : 01016-01016

Edp Sciences

Access to resources Recommend Favorite

Research on Tool Cutting Performance and Turning Simulation

MATEC Web of conference, Vol. 175, Iss. issue, 2018-07 ,pp. : 03059-03059

Edp Sciences

Access to resources Recommend Favorite

Empirical Modeling of Average Cutting Speed during WEDM of Gas Turbine Alloy

MATEC Web of conference, Vol. 221, Iss. issue, 2018-10 ,pp. : 01002-01002

Edp Sciences

Access to resources Recommend Favorite