Die Design for Main Bearing Cap of Engine Block Based Semi-Solid Die Casting Process and the Comparison Analysis with Squeeze Casting Process

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2019|285|429-435

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2019, Iss.285, 2019-02, pp. : 429-435

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Characterization of Microstructure and Shrinkage Porosity of a Semi-Solid Metal Slurry in Gravity Die Casting

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 161-166

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Primary α-Al Morphology in Slurry on Segregation during 357 Semi-Solid Die Casting

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 398-402

Trans Tech Publications

Access to resources Recommend Favorite

Addition of Swarf to Produce a Semi-Solid Slurry during High Pressure Die-Casting of AS9U3 Aluminum Alloy

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 271-276

Trans Tech Publications

Access to resources Recommend Favorite

Semi-Solid Casting of Pure Magnesium

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 464-469

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Rare Earth Additions on the Microstructure and Mechanical Properties of Al7Si0.3Mg Alloys Processed by Semi-Solid Die Casting and Gravity Die Casting

By  

Solid State Phenomena, Vol. 2019, Iss. 285, 2019-02 ,pp. : 69-74

Trans Tech Publications

Access to resources Recommend Favorite