Observation of Impact of Progressive Cooling System on Temperature Field Distributions on Surfaces of Injection Moulded Plastic Parts

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|669|19-28

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.669, 2016-02, pp. : 19-28

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Impact of Innovative Cooling System on Mechanical Properties of Moulded Parts

By  

Defect and Diffusion Forum, Vol. 2016, Iss. 368, 2016-08 ,pp. : 49-52

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and mechanical properties of injection moulded Nimonic-90 superalloy parts

By Özgün Ö   Gülsoy H Ö   Findik F   Yilmaz R  

Powder Metallurgy, Vol. 55, Iss. 5, 2012-12 ,pp. : 405-414

Maney Publishing

Access to resources Recommend Favorite

Interface Controlled Decarburisation Model for Injection Moulded Parts During Debinding

By Lin S. T.  

Powder Metallurgy, Vol. 40, Iss. 1, 1997-01 ,pp. : 66-72

Maney Publishing

Access to resources Recommend Favorite

Investigation on Wear Behavior of Bamboo Filler Reinforcement of Injection Moulded Plastic Gear

By  

Key Engineering Materials, Vol. 2017, Iss. 737, 2017-07 ,pp. : 119-123

Trans Tech Publications

Access to resources Recommend Favorite

Properties of Injection Moulded Fe—Cu Parts Made from Composite and Elemental Powders

By Huang C. T.   Hwang K. S.  

Powder Metallurgy, Vol. 39, Iss. 2, 1996-01 ,pp. : 119-123

Maney Publishing

Access to resources Recommend Favorite